IBM 7001578-J000 675W Power Supply for IBM System X3650 M3 X3530 M4 X3550 M3 X3690 X5

• Product Details
• Power Supply Tips

Product Details

Please make sure that you are ordering the correct power supply. All of the compatible models listed below come in different sizes and each size has a different power supply. Please check the part #'s, pictures and specifications carefully to make sure that you are ordering the correct power supply.

IBM System X3650 M3 X3530 M4 X3550 M3 X3690 X5 Power Supply PSU 675W 7001578-J000 7001484-J000 39Y7236
PART NUMBER: 7001578-J000
WATTAGE: 675W
Input: 100-127V, 7.8A / 200-240V, 3.8A 50/60HZ
Type: HOT SWAP

Compatible IBM System Model: X3530 M4, X3550 M3, X3620, X3650 M3, X3690 X5, X3550 M2, X3650 M2
Compatible Part No: 39Y7216, 39Y7218, 39Y7236, 39Y7235, 39Y7227
Compatible Model No: 7001578-J000, 7001578-J002, 7001484-J000, 7001484-J002
ADDITIONAL INFORMATION: HOT SWAP POWER SUPPLY

HOW TO REPLACE YOUR PC POWER SUPPLY.

1.Remove the dead pc power supply Once you've disconnected all the leads, look at the rear of the case and find the three or four screws holding the power supply in place. Remove them, then gently lift out the PS, making sure that the cabling doesn't get tangled on, say, a RAM module or expansion card and accidentally pull it loose.

2. Install the new IBM 7001578-J000 Pc power supply Out with the old, in with the new. Make sure the replacement Pc power supply is set to the correct voltage. Once the old PS is out, put the new one in its place and screw it in. Now just reverse the steps you performed: connect the leads to their respective outlets, replace any extracted components, and consult your photos to make sure you've left no lead unplugged. (You'd be surprised how easy it is to forget, say, the DVD lead, especially when you've spent 10 minutes trying to wedge in that pesky front-panel lead.)

3. Fire it up Before you close up the case, make sure everything works. Connect the power cord to the Pc power supply, plug in your monitor and keyboard, and fire up the machine. Unless you've failed to connect the main leads to the motherboard, it should come right to life, just like before. Let it boot completely, then check to make sure there's power to the optical drive(s) and, if applicable, the front panel.