Brand new L07658-004 PCH019 180W POWER SUPPLY FOR HP PRODESK 281 G3 400 G5 SLIMLINE DESKTOP PA-1181-3HC.
Please make sure that you are ordering the correct power supply. All of the compatible models listed below come in different sizes and each size has a different power supply. Please check the part #'s, pictures and specifications carefully to make sure that you are ordering the correct power supply.
Brand: For Hp
Model: DPS-180AB-26A,901765-003
Category: Server Power Supplies
Input Frequency: 50 ~ 60Hz
Input Voltage: 100 ~ 240V
Output Voltage: (180W)
Compatible Model:
HP ProDesk 600 G3 sff,
HP 400 G5 sff
Compatible Model Number:
DPS-180AB-26A DPS-180AB-30A D18-180P1A PA-1181-3HC PA-1181-3HV PCH019 PE-1181-3HL L08404-002 D18-180P2A
Compatible Part Number:
901765-003 901761-003 901764-003 L07658-003 L07658-004
1.Remove the dead pc power supply Once you've disconnected all the leads, look at the rear of the case and find the three or four screws holding the power supply in place. Remove them, then gently lift out the PS, making sure that the cabling doesn't get tangled on, say, a RAM module or expansion card and accidentally pull it loose.
2. Install the new hp PA-1181-3HC Pc power supply Out with the old, in with the new. Make sure the replacement Pc power supply is set to the correct voltage. Once the old PS is out, put the new one in its place and screw it in. Now just reverse the steps you performed: connect the leads to their respective outlets, replace any extracted components, and consult your photos to make sure you've left no lead unplugged. (You'd be surprised how easy it is to forget, say, the DVD lead, especially when you've spent 10 minutes trying to wedge in that pesky front-panel lead.)
3. Fire it up Before you close up the case, make sure everything works. Connect the power cord to the Pc power supply, plug in your monitor and keyboard, and fire up the machine. Unless you've failed to connect the main leads to the motherboard, it should come right to life, just like before. Let it boot completely, then check to make sure there's power to the optical drive(s) and, if applicable, the front panel.