Brand new PA-1181-3HB HP 180-Watts Power Supply For HP Prodesk 400 G5

• Product Details
• Power Supply Tips

Product Details

Enhance the performance of your HP ProDesk 400 G5 Small Form Factor desktop with the HP PA-1181-3HB 180W Power Supply Unit. Specifically engineered for reliable power delivery, this unit provides 180 Watts to support the demanding operational needs of your system while ensuring stable performance.
Input:
100-240V~, 50-60Hz, 2.3a

Output:
+12.1V: 14.88a max
180W

180W Power Supply For HP Prodesk 400 G5

Connectors
(1) 7-Pin Inline (21")
(2) 4-Pin 12V Connector (6 1/2" and 18 1/2")

Connectors
(1) 7-Pin Inline Connector (P2 5.25")
(2) 4-Pin 12V Connector (P1 14") & (P3 25.5")

Replaceability with the following models:
L07658-001 L17839-001 901764-003 L07658-004 PA-1181-3HB

Compatible Models:
HP ProDesk 400 G5 SFF, 600 G3 SFF, 600 G5 SFF, 280 G3 SFF

HOW TO REPLACE YOUR PC POWER SUPPLY.

1.Remove the dead pc power supply Once you've disconnected all the leads, look at the rear of the case and find the three or four screws holding the power supply in place. Remove them, then gently lift out the PS, making sure that the cabling doesn't get tangled on, say, a RAM module or expansion card and accidentally pull it loose.

2. Install the new hp PA-1181-3HB Pc power supply Out with the old, in with the new. Make sure the replacement Pc power supply is set to the correct voltage. Once the old PS is out, put the new one in its place and screw it in. Now just reverse the steps you performed: connect the leads to their respective outlets, replace any extracted components, and consult your photos to make sure you've left no lead unplugged. (You'd be surprised how easy it is to forget, say, the DVD lead, especially when you've spent 10 minutes trying to wedge in that pesky front-panel lead.)

3. Fire it up Before you close up the case, make sure everything works. Connect the power cord to the Pc power supply, plug in your monitor and keyboard, and fire up the machine. Unless you've failed to connect the main leads to the motherboard, it should come right to life, just like before. Let it boot completely, then check to make sure there's power to the optical drive(s) and, if applicable, the front panel.