Brand new D12-320P1A power supply Pack for HP 6005MT Elite 8000 PS-4321-9HA 503378-001 508154-001

• Product Details
• Power Supply Tips

Product Details

Please make sure that you are ordering the correct power supply. All of the compatible models listed below come in different sizes and each size has a different power supply. Please check the part #'s, pictures and specifications carefully to make sure that you are ordering the correct power supply.
MAX. OUTPUT POWER: 320W
Brand: For Hp
Model: PC8002
Category: Server Power Supplies
Input Frequency: 50 ~ 60Hz
Input Voltage: 100 ~ 240V
Output Voltage: (320W)
Connector: Connectors Included:
4 Pin ATX +12V Power Connector (1)
6-pin Auxiliary PCI-E Power (1)
6 Pin / 5 Cable Connector (1)
Replace the following part numbers
PC8002 ,639017-001 ,640129-001 ,DPS-320JB A ,D3201A0 ,D12-320P1A,HPD3201A0 ,HP-3201AO ,HPD3201E0 ,PC8022,702454-001,702306-002

Fits the Following Models
HP MT 6000 ,HP MT 6005 ,HP MT 6200 ,HP MT 6060 ,HP MT 6080 ,HP MT 6280 ,HP MT 6300 ,HP MT 6380 ,HP MT 8000 ,HP MT 8080 ,HP MT 8100 ,HP MT 8180 ,HP MT 8200 ,HP MT 8280 ,HP MT 8300 ,HP MT 8380 ,HP Z200 ,HP Z210 ,HP EliteDesk 800 G1 600G1 Tower ,HP Compaq pro 6005MT ,HP Compaq Elite 8000CMT

HOW TO REPLACE YOUR PC POWER SUPPLY.

1.Remove the dead pc power supply Once you've disconnected all the leads, look at the rear of the case and find the three or four screws holding the power supply in place. Remove them, then gently lift out the PS, making sure that the cabling doesn't get tangled on, say, a RAM module or expansion card and accidentally pull it loose.

2. Install the new hp D12-320P1A Pc power supply Out with the old, in with the new. Make sure the replacement Pc power supply is set to the correct voltage. Once the old PS is out, put the new one in its place and screw it in. Now just reverse the steps you performed: connect the leads to their respective outlets, replace any extracted components, and consult your photos to make sure you've left no lead unplugged. (You'd be surprised how easy it is to forget, say, the DVD lead, especially when you've spent 10 minutes trying to wedge in that pesky front-panel lead.)

3. Fire it up Before you close up the case, make sure everything works. Connect the power cord to the Pc power supply, plug in your monitor and keyboard, and fire up the machine. Unless you've failed to connect the main leads to the motherboard, it should come right to life, just like before. Let it boot completely, then check to make sure there's power to the optical drive(s) and, if applicable, the front panel.