Brand new HP D12-240P3A 240W Power Supply For HP ProDesk 400 600 G1 EliteDesk 600 705 800 Z230 SFF

• Product Details
• Power Supply Tips

Product Details

Please make sure that you are ordering the correct power supply. All of the compatible models listed below come in different sizes and each size has a different power supply. Please check the part #'s, pictures and specifications carefully to make sure that you are ordering the correct power supply.
HP D12-240P3A PCC002 PS-4241-2HF DPS-240AB-3 B power supply

Part Number : D12-240P3A
Max Output power:240W

Connectors
(1) 6-Pin (3x3) P1 Connector
(1) 6-Pin (Straight) P2 Connector
(1) 12V 4-Pin Connector

Brand new original HP Z240 600 800 G1 G2 SFF workstation power supply, rated at 240W.

HP ProDesk 800 G1 SFF original power supply
702307-002,751884-001
702309-002,751886-001


Inventory hp rated 240W active mute desktop computer power supply
model:
D12-240P3A D12-240P2A PS-4241-1HC
D12-240P1A PS-4241-2HF PS-4201-2HF

Compatible Models (not limited to)
EliteDesk 705 G1 SFF
EliteDesk 800 G1 SFF
ProDesk 400 G1 SFF
ProDesk 490 G1 SFF
ProDesk 600 G1 SFF
ProDesk 600 G2 SFF
ProDesk 690 G1 SFF
Z230 SFF Workstation

HOW TO REPLACE YOUR PC POWER SUPPLY.

1.Remove the dead pc power supply Once you've disconnected all the leads, look at the rear of the case and find the three or four screws holding the power supply in place. Remove them, then gently lift out the PS, making sure that the cabling doesn't get tangled on, say, a RAM module or expansion card and accidentally pull it loose.

2. Install the new hp D12-240P2A Pc power supply Out with the old, in with the new. Make sure the replacement Pc power supply is set to the correct voltage. Once the old PS is out, put the new one in its place and screw it in. Now just reverse the steps you performed: connect the leads to their respective outlets, replace any extracted components, and consult your photos to make sure you've left no lead unplugged. (You'd be surprised how easy it is to forget, say, the DVD lead, especially when you've spent 10 minutes trying to wedge in that pesky front-panel lead.)

3. Fire it up Before you close up the case, make sure everything works. Connect the power cord to the Pc power supply, plug in your monitor and keyboard, and fire up the machine. Unless you've failed to connect the main leads to the motherboard, it should come right to life, just like before. Let it boot completely, then check to make sure there's power to the optical drive(s) and, if applicable, the front panel.