Brand new HP 503378-001 320W Power Supply For HP Pro 6000 6200 6300 Elite 8000 8100 8200 8300

• Product Details
• Power Supply Tips

Product Details

Please make sure that you are ordering the correct power supply. All of the compatible models listed below come in different sizes and each size has a different power supply. Please check the part #'s, pictures and specifications carefully to make sure that you are ordering the correct power supply.
Power supply with interface: 4P * 1,6P * 1, P2 * 1
Applicable HP desktop and workstation power
supply: PS-4321-9HA HP-D3201EO HP-D3201E0 D10-320P2A D12-320P1B DPS-320MB A CFH0320AWWA PS-4321-9HP DPS-320NB A DPS-320NB-1 A D12-320P1B and other models Applicable models: For HP MT series (4000 4300 6000 6005 6080 6200 6280 6300 6380 8000 PC8022 8080 8100 8180 8200 8280 8300 8380 6380) and other models HP Compaq 8200 DPS-320NB-1
HP 6200 Pro 8200 Elite MT Microtower
HP Elite 6200 8200 CMT
HP Compaq 6000
Note :Cable pin three interfaces, only applies to the original HP chassis motherboard, not compatible with ordinary motherboard

Connectors
P1 = 6-Pin ATX (13")
P2 = 6-Pin (13")
P3 = 4-Pin 12V (14")

Replaceability with the following models:
PS-4321-9HA,HP-D3201EO,HP-D3201E0,HP-D3201A0,D10-320P2A,D12-320P1B,DPS-320MB A ,CFH0320AWWA,PS-4321-9HP,DPS-320NB A,DPS-320NB-1 A,D12-320P1B, 511483-001,613764-001,611483-001,611484-001,613765-001,503377-001,508153-001 ,503378-001,508154-001,707818-002,707906-001

Compatible Models:
HP Pro 6000
HP Pro 6200
HP Pro 6300
HP Elite 8000 MT
HP Elite 8100 MT
HP Elite 8200 MT
HP Elite 8300 MT

HOW TO REPLACE YOUR PC POWER SUPPLY.

1.Remove the dead pc power supply Once you've disconnected all the leads, look at the rear of the case and find the three or four screws holding the power supply in place. Remove them, then gently lift out the PS, making sure that the cabling doesn't get tangled on, say, a RAM module or expansion card and accidentally pull it loose.

2. Install the new hp 503378-001 Pc power supply Out with the old, in with the new. Make sure the replacement Pc power supply is set to the correct voltage. Once the old PS is out, put the new one in its place and screw it in. Now just reverse the steps you performed: connect the leads to their respective outlets, replace any extracted components, and consult your photos to make sure you've left no lead unplugged. (You'd be surprised how easy it is to forget, say, the DVD lead, especially when you've spent 10 minutes trying to wedge in that pesky front-panel lead.)

3. Fire it up Before you close up the case, make sure everything works. Connect the power cord to the Pc power supply, plug in your monitor and keyboard, and fire up the machine. Unless you've failed to connect the main leads to the motherboard, it should come right to life, just like before. Let it boot completely, then check to make sure there's power to the optical drive(s) and, if applicable, the front panel.