Brand new Power Supply 500W PA-3501-3DA For Dell Optiplex 5080MT 7080MT 3671.All power supplies are tested by our in house technicians and they are guaranteed to function properly.
Please make sure that you are ordering the correct power supply. All of the compatible models listed below come in different sizes and each size has a different power supply. Please check the part #'s, pictures and specifications carefully to make sure that you are ordering the correct power supply.
MAX. OUTPUT POWER: 500W
AC INPUT
100-240 V~/7 A 50/60Hz
DC OUTPUT
+12 VA1 ==/18A
+12 VA2 ==/18A
+12 VB ==/18A, +12 VC==/18 A
Dimensions
83mm x 63mm x 220mm
Connectors
(1) 6-Pin Connector (P1) 9.5")
(1) 6-Pin Connector (P5) (11.5") On Same Cable As P3
(1) 6+2 Pin Connector (P3) (15") On Same Cable As P5
(2) +12V 4-Pin Power Connector (22") (22")
Compatible Part Number: Dell L500EPM-00 , PA-3501-3DA, CN-099TPH, 99TPH, 099TPH, D500EPM-00, H500EPM-00, L500EPS-00 , DPS-500AB-49 A
Compatible For Dell Desktop:
Dell XPS 8940,
Dell G5 5090,
Dell OptiPlex 7070, 7080, 5090, 5060
Dell Optiplex
7090MT 7080MT 7070MT 7060MT
5050MT 5070MT 5080MT 5090MT
3050MT 3060MT 3070MT 3080MT 3090MT
3650MT 3670MT 3671MT 3260MT 3681MT
1.Remove the dead pc power supply Once you've disconnected all the leads, look at the rear of the case and find the three or four screws holding the power supply in place. Remove them, then gently lift out the PS, making sure that the cabling doesn't get tangled on, say, a RAM module or expansion card and accidentally pull it loose.
2. Install the new dell PA-3501-3DA Pc power supply Out with the old, in with the new. Make sure the replacement Pc power supply is set to the correct voltage. Once the old PS is out, put the new one in its place and screw it in. Now just reverse the steps you performed: connect the leads to their respective outlets, replace any extracted components, and consult your photos to make sure you've left no lead unplugged. (You'd be surprised how easy it is to forget, say, the DVD lead, especially when you've spent 10 minutes trying to wedge in that pesky front-panel lead.)
3. Fire it up Before you close up the case, make sure everything works. Connect the power cord to the Pc power supply, plug in your monitor and keyboard, and fire up the machine. Unless you've failed to connect the main leads to the motherboard, it should come right to life, just like before. Let it boot completely, then check to make sure there's power to the optical drive(s) and, if applicable, the front panel.