Brand new D750E011P Power Supply for Dell Dell Alienware R13 R14 T3660 XPS 8950.All power supplies are tested by our in house technicians and they are guaranteed to function properly.
Please make sure that you are ordering the correct power supply. All of the compatible models listed below come in different sizes and each size has a different power supply. Please check the part #'s, pictures and specifications carefully to make sure that you are ordering the correct power supply.
This power supply has the following connectors:
AC INPUT
100-240V~, 50-60Hz, 10A
DC OUTPUT
+12.0VA == 36A
+12.0VB == 27A
+12.0VC == 36A
Dimensions
150mm x 62mm x 185mm
Connectors:
(1) 10-Pin Connector (ATX SYS 11.5")
(2) 6-Pin Connector (GFX2 14") On Same Cable As GFX1 (GFX4 14") On Same Cable As GFX3
(2) 6+2 Pin Connector (GFX1 17.5") On Same Cable As GFX2 (GFX3 17.5") On Same Cable As GFX4
(2) +12V 4-Pin Power Connector (ATX CPU1 9") (ATX CPU2 9")
Part Numbers:
MP23Y,
M2G8X,
FT44X,
M2G8X,
M92DC,
AC750EPS-00,D750E011P,
H750EPS-00,
D750E013P,
PA-3751-8DA,
PCL012
Compatible For Dell Desktop:
Dell Alienware R13
Dell Alienware R14
Dell Precision 3660 Tower Workstation
Dell XPS 8950
1.Remove the dead pc power supply Once you've disconnected all the leads, look at the rear of the case and find the three or four screws holding the power supply in place. Remove them, then gently lift out the PS, making sure that the cabling doesn't get tangled on, say, a RAM module or expansion card and accidentally pull it loose.
2. Install the new dell H220AS-00 Pc power supply Out with the old, in with the new. Make sure the replacement Pc power supply is set to the correct voltage. Once the old PS is out, put the new one in its place and screw it in. Now just reverse the steps you performed: connect the leads to their respective outlets, replace any extracted components, and consult your photos to make sure you've left no lead unplugged. (You'd be surprised how easy it is to forget, say, the DVD lead, especially when you've spent 10 minutes trying to wedge in that pesky front-panel lead.)
3. Fire it up Before you close up the case, make sure everything works. Connect the power cord to the Pc power supply, plug in your monitor and keyboard, and fire up the machine. Unless you've failed to connect the main leads to the motherboard, it should come right to life, just like before. Let it boot completely, then check to make sure there's power to the optical drive(s) and, if applicable, the front panel.